RTCM Messages unknown via UART

0 votes
64 views

I wrote a small C program for transmitting RTCM3 correction messages to the board via usb, this worked fine and  the board was receiving the messages. Now I changed the connection from usb to UART and all data which is received via the UART is unknown to the board.

 

 

What do I have to change in the configs that the correction data is correctly received?

thanks in advance

asked Feb 13 by mstranne

1 Answer

+1 vote

My thoughts would be:

  1. Baud rate mismatch
  2. RTCM3 is not enabled as input protocol on UART (CFG-PRT message)
answered Feb 13 by grumpy Senior Principal Expert
I have checked both should be right..

Do you have another idea what could be wrong?