RTCM Messages unknown via UART

0 votes

I wrote a small C program for transmitting RTCM3 correction messages to the board via usb, this worked fine and  the board was receiving the messages. Now I changed the connection from usb to UART and all data which is received via the UART is unknown to the board.



What do I have to change in the configs that the correction data is correctly received?

thanks in advance

by mstranne asked Feb 13, 2018
+1 vote

My thoughts would be:

  1. Baud rate mismatch
  2. RTCM3 is not enabled as input protocol on UART (CFG-PRT message)
by grumpy answered Feb 13, 2018
I have checked both should be right..

Do you have another idea what could be wrong?
website banner